Description
316 Stainless Steel Aqualine Wing Cleats
Our 316 Stainless Steel Aqualine Wing Cleats are hand polished to a mirror finish.
In its closed position, the unit’s low profile will not interfere with the sleek lines of your boat, and when lifted to its ‘in use’ position, great care has been taken to ensure that expensive mooring lines are not damaged by chafe.
Each cleat has 3 M16 studs (M12 for 280mm unit) to give a clean under surface mounting, in addition to the 2 M16 sheer pins that give even more side loading strength, making it suitable for most boats up to 100ft in length.
Only 5 drill holes needed for fitting, making it an easy “one man job”. Our 316 Stainless Steel Aqualine Wing Cleats have been load tested well in excess of mooring rope failure loads. As a result we will not accept responsibility for damage caused by overloading or due to misuse.
Available in 3 Sizes
CQ-9336102 | Length 280mm | 9.46T | Technical Drawing
CQ-9336100 | Length 360mm | 20.12T | Technical Drawing
CQ-9336101 | Length 480mm | 24.5T | Technical Drawing
Load test results shown are failure point.
Our range of hardware has until now, only been available to the world’s most exclusive Yacht Builders. Cast by a team of highly experienced specialists, then hand polished to give a depth of shine that differentiates the exceptional from the average.
